vefthegreen.blogg.se - Seagate seatools logs

#Seagate seatools logs how to
#Seagate seatools logs software
#Seagate seatools logs license

The drive is working on its own at these times and the system may decide it should go into Stand By or Hibernate modes. A complete drive scan may take a few hours to complete.

Keep the computer fully powered on – Power management controls may need to be suspended while doing very long tests.

Most desktop and notebook systems have one SATA or PATA internal drive. Internal drives are identified as PATA (Parallel ATA or IDE), SATA (Serial ATA), SCSI or SAS (Serial-Attached SCSI).

SeaTools’ Drive Identification – External drives that connect to the system through USB, 1394 Firewire or eSATA do not have the same background activity as the Internal drive.

This is harmless to the drive and a routine condition of use however, it causes the SeaTools tests to take much longer time to complete. When that happens, SeaTools will temporarily suspend its current progress while the drive is busy. Otherwise, Windows will continue to give the disc drive commands to access data for the needs of the other applications. The main reason for this is to keep the drive focused on SeaTools as much as possible.

Isolate SeaTools – close all other applications before running a hard disc diagnostic.

Launch SeaTools by following these steps once it is installed:

#Seagate seatools logs how to

Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again.This post describes how to run SeaTools for Windows and provides some comprehensive advice about using the test to assist in troubleshooting. If the drive is on a controller card then it is possible that the set drive size command may not work. Make sure the drive is connected directly to the motherboard and not to a third-party controller card. If a message in red displays, then an error occurred. Remove the SeaTools diskette/CD, power off the computer for a few seconds, then reboot and check the capacity of the drive again in the BIOS. If you get an OK message in white in the middle of the screen, then the process was successful.

Click the "R - Reset to Maximum" button.

Click "C - Set Capacity" at the top of the screen.If this is not the current drive, click the "D - Drive" button in the upper left until you see the drive you want to test displayed in the middle of the screen. The model number of the drive currently selected is displayed here. You can see what device is selected by looking in the middle of the screen. Look at the bottom portion of the window to see what drives are listed and what device number they are. Now choose the drive for which to set the size.

#Seagate seatools logs license

Click "I agree" to the license agreement.

Once booted from the SeaTools for DOS diskette or CD, the computer should display a screen with a license agreement. 137GB or 32GB) and it is a computer that should support a drive that large, then this would be a time to set the drive size.

For example, if the drive is showing up as a smaller capacity in the BIOS (i.e.

#Seagate seatools logs software

Sometimes it is necessary to use the SeaTools for DOS software to get the drive back to its native capacity.